Cipher Lab Kernel Update Procedures - CipherLab CIPHER Lab CPT-8061 Use And Installation Manual

Wireless scanner

Table of Contents

5.3 CIPHER Lab Kernel Update Procedures

To upload kernel updates (supplied by CIPHER Labs) to each wireless scanner,

perform each of the following tasks:

Step 6 in Section 4.2.1 (Preparing CPT-8061) provides instructions on how to

connect the Charging and Communications cradle to the serial port of the PC from

which the firmware update will be loaded. If you have not already performed each

of the tasks outlined in Step 6, they must be completed at this time. The PC sends the

Scan-IT interface software on to each communications cradle via this serial

connection. The cradle in turn "transmits" the software to the wireless scanner via an

Infrared laser light emitted from a red window located in the large slot at the top of the

cradle, to another red window located on the bottom of the scanner unit.

2. Place the CPT-8061 scanner facing forward into the large slot located at the top of the

Charging and Communications cradle. The metal contacts located on the bottom of the

scanner unit must make firm connection with the metal prongs located in the large

slot at the top of the cradle. Leave the nylon hand cord (attached to the lower left

corner of the scanner) hanging out the left side of the cradle. Make sure the scanner

is turned off at this point!

3. Simultaneously press the <7> and <9> keys and the

front corner of the scanner. Wait for the scanner to beep three times, then turn the

scanner off by pressing the

After three beeps, turn scanner off by pressing

Appendix B: Settings Worksheet / Miscellaneous

<Power>

key.

Figure 81: Powering the Scanner On and Off

Simultaneously Press <7> + <9> + <Power>,

<Power>

key in the lower right

<Power>

again

Table of Contents