Table of Contents
Advertisement
PARTS INCLUDED:
1 Radome
1 Power switch
1 Wall plate (white)
1 Surface mount box
1 Cable entry plate
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
Level
Drill w/3/4" bit
1-1/4" hole saw (if mounting switch in wall)
3/8" Box/Open end wrench for dome screws
7/16" Open end wrench
UNPACKING THE UNIT
. Open box and remove packing material.
1
!
!
2. Lift unit out of box vertically. Do not turn box and
"roll" out, or turn upside down to remove.
!
Parts Included • Tools Needed • How to Unpack
If using knife to open
carton, BE CAREFUL.
Do not cut the dome on
the unit.
BE CAREFUL when
removing unit. Dome is
attached to base by
ONLY THREE PEICES
OF TAPE!
USE 2 PEOPLE
when removing the unit
from the carton.
Do not paint dome!
Painting dome will cause
signal degradation.
1 large yellow spade connector
2 small red spade connectors
All required screws and washers
1 base with electronics, dish, single LNBF
30' power cable and 30' coaxial cable
Phillips screw driver #2
Sealant (consult RV manufacturer for proper type
for your roof material)
LIFT UNIT STRAIGHT UP
OUT OF CARTON!
6
Advertisement
Table of Contents
