Table of Contents
Advertisement
About this manual —
We hope this manual will provide clear instructions to install and operate the MV-0022.
Two symbols have been used —
!
PARTS INCLUDED:
1 Radome
3 base mounting feet
1 Power switch
2 Wall plates (white & brown)
1 Surface mount bracket
2 Cable clamps
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
7/16" open end wrench
Level
Drill w/3/4" bit
1-1/4" hole saw (if mounting switch in wall)
5/16" Socket for roof screws
1/8" Allen wrench
UNPACKING THE UNIT
1. Open box and remove packing material.
!
2. Lift unit out of box vertically. Do not turn box and
"roll" out, or turn upside down to remove.
Parts Included • Tools Needed • How to Unpack
Indicates caution should be taken!
If using knife to open
carton, BE CAREFUL.
Do not cut the dome on
the unit.
USE 2 PEOPLE
when removing the unit
from the carton.
Indicates suggestions to make
processes easier for you.
1 Cable entry plate
1 large yellow spade connector
2 small red spade connectors
All required screws and washers
1 base with electronics, dish, stacked LNBF
1 tube silicone
1/2" Open end wrench
Crimping tool for coax connections
Crimping tool for electrical connections
Small blade screw driver
Pliers
Sealant (consult RV manufacturer for proper type for
your roof material)
LIFT UNIT STRAIGHT UP
3
Advertisement
Table of Contents
