Parts Included; Unpacking The Unit - Winegard Movin' View MV3535A Manual

PARTS INCLUDED:

1 Radome
1 Power switch
1 Wall plate (white)
1 Surface mount box
1 Cable entry plate
3 Base feet
large yellow flag connector
2 small red flag connectors
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
Level
Drill w/3/4" bit
1-1/4" hole saw (if mounting switch in wall)
Phillips screw driver #2

UNPACKING THE UNIT

. Open box and remove packing material.
1
!
!
2. Lift dome out of box vertically. Then lift unit out of
box vertically. Do not turn box and "roll" out, or turn
upside down to remove.
USE 2 PEOPLE
when removing the unit
from the carton.
DO NOT PAINT DOME!
!
Painting dome will
cause signal
degradation.
Parts Included • Tools Needed • How to Unpack
If using knife to open
carton, BE CAREFUL.
Do not cut the dome on
the unit.
BE CAREFUL when
removing unit. Dome is
attached to base by
only 3 pieces of tape,
NOT BY SCREWS.
All required screws, washers, bolts, and nylocks
1 base with electronics, dish, dual LNBF
Silicone sealant
Surface Wipes
30' Coax Cable
30' Power Cable
3/8" Open end wrench
7/16" Open end wrench
Sealant (consult RV manufacturer for proper type
for your roof material)
LIFT UNIT STRAIGHT UP
OUT OF CARTON!
5
REV. 12/05