Advertisement
PARTS LIST
FIGURE 1
Front Assembly
Rear Assembly
Boom Brace
Mast Clamp
ASSEMBLY
STEP 1 - Contents of Package
A. Remove all parts from the box and compare to parts
list to ensure nothing is missing and to become
familiar with the part names. See FIGURE 1.
STEP 2 - Front Section
A. Stand front section up vertically and unfold all
elements (in any order) until they snap into place.
B. Remove bolt, hex nut, and director element from the
front section boom. See FIGURE 2.
C. Unfold the UHF directors. See FIGURE 2.
D. Set front section aside being careful not to bend
the elements (laying it flat on the ground is the
best position).
FIGURE 2 - Front Assembly
UHF Director,
(Unfolded)
UHF Directors
Director Element
Corner Reflector Assembly (2)
Mast Clamp
NOTE: Unfolding elements procedure is the same for both
HD7698P
STEP 3 - Rear Section
A. Stand rear section up vertically with cartridge
B. Alternately unfold elements per FIGURE 3 in
C. Spin the rear section around so the cartridge
FIGURE 3 - Rear Assembly
UHF Directors
Cartridge
Boot
Housing
HD8200U antennas.
&
housing up and facing away from you.
direction of arrows until they lock into place in the
black plastic blocks.
housing is now facing you. Unfold the remaining
elements in the same order. See FIGURE 3 for
completely unfolded rear section.
8 Up
6 Up
4 Up
&
Over,
Down
2 Up
&
Over,
Down
TOOLS REQUIRED
(not included)
Flat Head Screwdriver
Phillips Screwdriver
Crescent Wrench or Pliers
Cartridge Housing
7 Down
5 Down
3 Down
1 Down
Advertisement
