Rear View - Rena Systems Envelope Imager XT 3.0 Operation Manual

SECTION 1
GETTING ACQUAINTED

Rear View

10
9
USB PORT – Connects the printer to the USB port of your computer.
9.
PARALLEL PORT – Connects the printer to the Centronics Parallel port of your computer.
10.
FEEDER INTERFACE CONNECTOR – Allows connection to an optional feeder, so the
11.
printer can stop/start the feeder appropriately.
VACUUM SWITCH – This switch controls the power to the vacuum fans.
12.
MEDIA SIDE GUIDE SECURING KNOBS – Used to secure the positions of the Media
13.
Side Guides.
OUTER HOLD-DOWN STRAPS & SECURING KNOBS – Holds down the sides of the
14
media to help guide it under the printheads.
MEDIA HOLD-DOWN STRAP & SECURING KNOB – Holds down media to help guide
15.
it under the printheads.
MOTOR CIRCUIT BREAKER – The circuit breaker protects the printer's motor from
16.
overload.
MAIN POWER SWITCH & POWER RECEPTACLE – This assembly contains the Main
17.
Power Switch, Power Receptacle and Line Fuses.
8
11 12
Figure 3
13
Envelope Imager XT3.0/XT4.0 Operations Rev. 6/15/2007
14
15
16
17