Setup (Basic) ► Serial Ports Setup - CalAmp GEMINI G3 User Manual

SETUP (BASIC) ► SERIAL PORTS SETUP
4.7.2.3
The GeminiG3 serial ports can be logically connected to local and remote services to aid in configuration and
troubleshooting, or they can be connected to a remote Host application or even to the serial port of a remote
unit.
Figure 16 - Setup (Basic) – Serial Ports Setup
Item
Enabled
Speed
Data bits
Stop bits
Parity
Flow Control
Connection Control
IP Gateway Service
IP Gateway Transport
Local IP Address
Local IP Port
Independent check boxes to activate DEV-1 PORT and/or DEV-2 PORT
Select 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 Baud Rate
Number of bits making up the data word. Set according to Host configuration. Default is 8.
Marks the end of the serial port data byte. Default is 1.
Added to identify the sum of bits as odd or even. Default is None.
Select None or CTS-based (RTU dependent)
Select Permanent (3-wire) or Switched (DTR bringup/teardown) (RTU dependent)
Select one of:
CLI Service (Command line interface) RS-232 connection to Host PC (Default = SETUP)
GPS – Direct GPS reports (see GPS ► Delivery) to this serial port
Custom – Choosing Custom enables the IP Gateway Transport configuration
Available only if IP Gateway Service selection is Custom. Choose the socket connection
mode from the drop-down list box choices of TCP Server, TCP Client, or UDP.
Valid unicast or multicast IP address, including the local Loopback interface address.
Default local IP address is set to 0.0.0.0 and can be changed dynamically without a unit reset.
For TCP Client and UDP socket connections, set to any value between 1 and 65535.
For TCP Server socket connections, set to any value between 1 and 65535 but must not be set
to one of the following values or fall within the following ranges of values: 20, 21, 23, 123, 520,
5002, 6254 to 6299, 7000 to 7100. Otherwise, the parameter configuration will be accepted, but
no socket connection will be established to accept connection from remote endpoints.
Default local port value is set to 1024 and can be changed dynamically without a unit reset.
Description
32