Grandstream Networks HandyTone-488 User Manual page 6

HandyTone-488 User Manual
HandyTone-488 has one FXS port and one FXO port. The PHONE port next to the LAN port is a FXS
port. The LINE port on the side of the HandyTone-488 is a FXO port. Both the FXS port and the FXO
port can have a separate SIP account. This is a key feature of HandyTone-488 as it supports
simultaneous call on both FXS port and FXO port. Telephone calls can be originated from or
terminated on the PSTN network via FXO port remotely.
Following are the steps to install a HandyTone-488:
1. Connect a standard touch-tone analog telephone to the PHONE port.
2. Insert a standard RJ11 telephone cable into the LINE port and connect the other end of the
telephone cable to a wall jack.
3. Insert the Ethernet cable into the WAN port of HandyTone-488 and connect the other end of
the Ethernet cable to an uplink port (a router or a modem, etc.)
4. Connect a PC to the LAN port of HandyTone-488 if HT488 is used as a router.
5. Insert the power adapter into the HandyTone-488 and connect it to a wall outlet.
Please follow the instructions in section 6.2 to configure the HandyTone-488.
6
Grandstream Networks, Inc.