Filling The Hydraulic Circuits - ELEKTRA Professional espresso coffee machines User Manual

9 FILLING THE HYDRAULIC CIRCUITS (K-S-M-C-B)
1) Ensure that the water supply is turned on.
2) Switch on the machine by turning the main switch from position "0" to "1":
the machine goes on and loads water into the boiler, while powering the heating elements.
10 FILLING THE HYDRAULIC CIRCUITS (Kwts)
Before switching on the machine, fi ll the water treatment hydraulic circuit.
Proceed as follows:
1) Open the water softener cap.
2) Open the activated carbon cap and take the cartridge out.
3) Top up with water the cartridge container until the water softener has fi lled up completely
and starts overfl owing.
4) Close the water softener cap.
5) Put the activated carbon cartridge in, top up with water to the brim and reclose.
6) Turn on the water supply.
Now the machine is ready to be switched on and adjusted.
If there are problems in opening the two caps, consult chapter "J – TROUBLESHOOTING".
64