Sub-Zero PRO 48 Installation Instructions Manual page 18

P R O 4 8
D O O R
D O O R H I N G E A D J U S T M E N T
The door must be removed to adjust door
hinges. To remove the door, lift up the vent
portion of the top grille, open the door to
about 45° and lift the door off the cabinet
hinges. Remove the hinge pins.
Loosen the two door hinge fasteners, slide
hinge to the desired position and retighten the
fasteners. Refer to the illustrations below. Rein-
stall hinge pins and door. Check alignment and
door seal. Close the vent portion of the top
grille.
18
I N S TA L L A T I O N I N S T R U C T I O N S
A D J U S T M E N T
Door hinge adjustment
When adjusting cabinet and door hinges,
it is important to keep the hinges parallel
to the face of the door and side of the
cabinet. The door switch will not function
if the hinges are excessively misaligned,
which will cause the lights to stay on and
the fan to not operate. This will result in
elevated cabinet temperatures. After
hinge adjustments are made, check that
the door switch is functioning properly.
Door hinge adjustment