Sub-Zero PRO 48 Installation Instructions Manual page 17

P R O 4 8 I N S T A L L A T I O N I N S T R U C T I O N S
D O O R A D J U S T M E N T
Check to make sure that both doors are
properly adjusted. If not, adjustments can be
made to the cabinet and door hinges.
IMPORTANT NOTE: Be sure the unit is
properly leveled before doing any cabinet or
door hinge adjustment.
C A B I N E T H I N G E A D J U S T M E N T
The door must be removed to adjust cabinet
hinges. To remove the door, lift up the vent
portion of the top grille, open the door to
about 45° and lift the door off the cabinet
hinges. Remove the hinge pins.
Cabinet hinge adjustment
Loosen the two cabinet hinge fasteners
1
/ turn. Refer to the illustration below. Rein-
2
stall hinge pins and door. Open the door and
using the Allen wrench provided, turn the
adjustment screw to relocate the cabinet
hinge. Close the door and check alignment.
Repeat these steps until the door is properly
aligned.
Remove the door and hinge pins again and
tighten the two cabinet hinge fasteners. Rein-
stall hinge pins and door and close the vent
portion of the top grille.
Hinge pins may stick in the door rather
than the cabinet hinge and may fall out of
the door after a few seconds, which could
cause damage to floors or injury.
1
/ to
4
17