Sub-Zero PRO 48 Installation Instructions Manual page 16

P R O 4 8
WAT E R L I N E
Approximately 0,9 m of 6,35 mm plastic
tubing is connected to the ice maker with a
preassembled 6,35 mm compression
connection at the end. This tubing is located
under the unit.
The water line fitting connection kit,
provided with the unit, contains a 6,35 mm
compression sleeve and a 6,35 mm compres-
sion nut for connection to the household
water line. Place the compression nut and
sleeve on the water line and fasten to the
connection at the end of the tubing under
the unit. Do not over tighten. Check all water
line fittings for leaks. Make sure that the
drain pan can be installed or removed
without any water line interference.
IMPORTANT NOTE: Be sure to purge the
water line prior to final connection to the
unit. This will remove any debris that may
be present in the tubing from installing the
new water line.
IMPORTANT NOTE: Let your customer
know that the ice maker will not produce ice
immediately, and that the first bucket of ice
produced should be discarded. Allow 48
hours of ice production, before discarding
the first bucket of ice.
16
I N S TA L L A T I O N I N S T R U C T I O N S
C O N N E C T I O N L E V E L I N G T H E U N I T
Once the unit is in position, extend the front
leveling legs down by turning the legs
counterclockwise and adjust the height. The
rear height adjustment can be made from
the front of the base. Use a 8 mm socket to
adjust the rear rollers. Turn the 8 mm hex
bolt clockwise to raise the unit or counter-
clockwise to lower it.
When the unit is leveled properly, or squared
off, door and/or drawer adjustments are less
likely to be necessary. Refer to the illustra-
tion below for location of the rear roller base
adjustment.
IMPORTANT NOTE: Be sure to reference
leveling of the unit to the floor and not to
surrounding cabinetry. This could affect the
operation of the unit, such as doors not
closing properly.
I N S TA L L T H E K I C K P L AT E
To install, screw the kickplate to brackets
attached to the inside surface of each roller
base.
Rear roller base adjustment