Table of Contents
Advertisement
A R M I N G S T A Y : P R O T E C T I N G Y O U R S E L F AT H O M E
Arming in the Stay mode allows you to remain home with the perimeter protection active but with the interior protection off,
so that you may move freely within the premises.
1
Check the Touchpad indicators. The green STATUS light must be ON-STEADY, and the LCD display will read
"SYSTEM READY", indicating that the system is ready to arm.
SYSTEM READY
Press the STAY button.
2
The Touchpad will voice prompt the correct action.
STAY
3
The red ARMED light will light steady and the LCD display will read "ARMED STAY", indicating the system is armed
in the Stay mode.
ARMED
To Arm in Night Mode from Stay Mode:
If already armed in Stay mode, the LCD display will read "ARMED STAY". If the F-64TPBR Touchpad is located in
the bedroom--and you are certain you will only be staying within this bedroom--you can arm in Night mode.
Arming in the Night mode allows you to remain home with all perimeter AND interior protection active--except for
the F-64TPBR Touchpad PIR--allowing you to move about the protected bedroom freely.
To arm in Night mode from Stay mode, simply press the NIGHT button. The green STATUS light will turn on
momentarily, the LCD display will read "ARMED NIGHT" and the red ARMED light will then light steady. See page
7 for more information regarding Night mode.
6
• If the green STATUS light is off and zones are scrolling in the display, a perimeter zone is faulted or a monitored
deadbolt is unlocked. Check the open zones listed and close the door, window, or lock the deadbolts as needed.
If you cannot immediately secure the zones or lock the deadbolts, they may be bypassed (see page 9).
• If you change your mind after pressing AWAY, press RESET to clear arming.
"System armed Stay"
Advertisement
Table of Contents
