Arming When Staying Home - NAPCO FREEDOM Manual

Arming in the Stay mode allows you to remain home with the perimeter protection active and the interior protection off, so
that you may move freely about the premises.
1
READY
2
STAY
ARMED
STAY
3
The STAY indicator will stop flashing and light steady, indicating the system is armed in the Stay mode.
STAY
8
A R M I N G W H E N S T AY I N G H O M E
Check the F-TP Touchpad indicators. The green
that the system is ready to arm.
•
If the green READY light is BLINKING, this indicates that a zone is faulted. The READY light is blinking out the zone
number of the open zone. Count the flashes and look at your zone list to see which zone is open and secure it (close
the door or window, etc.). If you cannot immediately secure the zone, it may be bypassed (see page 7).
•
If the green READY light is OFF, another monitored deadbolt is not locked. All other monitored deadbolts must be
locked before the system can be armed. Go to the other deadbolt location and lock it.
Press the STAY button.
If the deadbolt is already locked, the ARMED indicator will light and STAY will begin to flash, indicat-
ing the 60 second exit delay period. The system will arm in the Stay mode in 60 seconds.
If the deadbolt is NOT locked, lock the deadbolt from the inside to arm the system.
If the deadbolt has not been locked within 60 seconds of pressing
back to a disarmed state.
light should be ON-STEADY, indicating
READY
, the system will revert
STAY