Outside Air Installation; Blower Cord Installation & Snap Disc Operation; Blower Operation - Quadra-Fire 5100-I Manual

Hide thumbs Also See for 5100-I:

Specifications (8 pages)

Table Of Contents

Table of Contents

Tools Needed: Phillips Head Screwdriver

1) Remove cover from rear of stove by removing screws.

2) Remove the 2 Air Control spring handles.

3) Remove the lower grill by removing 2 screws in the center of the grill.

4) Unplug the snap disc by-pass switch and speed control from the wiring harness for easier access to blower.

(Located on right hand side of stove as you face the unit).

5) Mount the cover you removed from the back to the front to block room air from entering through the front lower grill.

6) Re-connect snap disc & speed control to wiring harness and replace screws in blower frame.

7) Reinstall lower grill, replace screws & spring handles.

8) Push insert back into the fireplace.

9) Plug blower cord back into outlet.

NOTE: The 5100-I requires replacement of combustion air. If your home is fairly air-tight, it is receommend that

you install outside air. If you are installing into a Mobile Home, outside air is required. See page 9.

The 5100-I is equipped with a 110°thermally operated snap disc which will automatically turn on the blower when the insert

reaches this temperature. The snap disc is located at the center of the insert, under the lower grille. There is a manual

override switch on the right side of the insert. The blower can be controlled manually by switching this switch to ON and

operating the blower with the speed control. If the blower does not come on automatically when the stove reaches a suf-

ficient temperature, the snap disc might be bad and should be replaced.

The 5100-I Insert comes standard with 2 blowers, installed at the factory with blower cord on right side of insert (as you face

the unit). The blower cord can also be installed on the left side. Disconnect the cord from right side and reinstall on the left

side. ROUTE WIRES BEHIND THE BLOWER. Do not route cord under or in front of appliance.

January 30, 2004

5100-I WOOD INSERT