Kyocera DF-760 Operation Manual page 15

Hole Punch Mode
DF-760(B), MT-720(B), BF-720, PH-5A, PH-5B AND PH-5C OPERATION GUIDE
2
Load the originals in the Document Processor, or
one at a time on the Platen.
NOTE:
Refer to the Operation Guide for the machine
for Document Processor and Platen specifications.
A maximum of 16 sheets can be bound in a single
operation. Up to 64 original sheets can be loaded at
one time.
3
Select other features as required and press Start.
4
Copies will be automatically stapled and ejected
onto the folding tray.
If the maximum capacity is reached, a message
displays. Remove all copies from the folding tray to
continue.
NOTE:
For further information refer to Center-Folding
Unit (option) on page 38.
5
On completion of the job, remove the copies from
the folding tray.
This mode produces hole punched copies
automatically.
Hole Punch mode can be used with Sort: ON, Staple
and Sort: OFF modes.
The following paper sizes can be used:
Inch models
• 2-hole punch: 8
1/2
5 8 ", A3, B4, A4, A4R, B5, B5R,
×
1/2 1/2
A5R and Folio
• 3-hole punch: 11
×
Metric models
• 2-hole punch: A3, B4, A4, A4R, B5, B5R, A5R,
Folio, 8 14", 8
×
1/2
• 4-hole punch: A3, A4, 11
Paper weights must be between 45 g/m
NOTE:
Punching requires the optional punching unit.
Tray C cannot be specified as the output destination
for punch mode.
1
Select Hole Punch mode on the operation panel of
the machine.
English
14", 8 11",
× ×
1/2
17", 11 8 ", A3 and A4
×
1/2
11" and 5 8
× ×
1/2 1/2
17" and 11 8
× ×
2
and 220 g/m
"
1/2
"
1/2
2
.
13