Installation Instructions; Before You Begin - GE Profile DPVH890 Owner's Manual & Installation Instructions

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: ge.com
In Canada, call 1.800.561.3344 or visit geappliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT
• – Save these instructions for
local electrical inspector's use.
IMPORTANT
• – Observe all governing codes
and ordinances.
• Install the clothes dryer according to the
manufacturer's instructions and local codes.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Clothes dryer installation must be performed
by a qualified installer.
• This dryer must be exhausted to the outdoors.
• Before the old dryer is removed from service or
discarded, remove the dryer door.
• Service information and the wiring diagram are
located in the control console.
• Do not allow children on or in the appliance.
Close supervision of children is necessary when
the appliance is used near children.
• Proper installation is the responsibility
of the installer.
• Product failure due to improper installation
is not covered under the Warranty
• To reduce the risk of severe injury or death,
follow all installation instructions.
FOR YOUR SAFETY:
• Use only rigid metal or flexible metal 4-inch
• Do not install a clothes dryer with flexible plastic
• This appliance must be properly grounded and
• Do not install or store appliance in an area where
• The National Fuel Gas Code restricts installations
• Install the dryer where the temperature is above
FOR GAS MODELS ONLY:
.
NOTE: Installation and service of this dryer must
be performed by a qualified installer, service
agency or the gas supplier.
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed
• When using ball-type gas shut-off valves, they
• A flexible gas connector, when used, must not
13
DPVH890 and UPVH890
WARNING
diameter ductwork for exhausting to the
outdoors. Never use plastic or other combustible
easy-to-puncture ductwork.
venting materials. If flexible metal (foil type) duct
is installed, it must be of a specific type identified
by the appliance manufacturer as suitable for use
with clothes dryers. Flexible venting materials are
known to collapse, be easily crushed, and trap
lint. These conditions will obstruct clothes dryer
airflow and increase the risk of fire.
installed as described in these instructions.
it will be exposed to water and/or weather.
of gas appliances in garages. They must be 18
inches off the ground and protected by a barrier
from vehicles.
50°F for satisfactory operation of the dryer
control system.
plumber or gas fitter.
shall be T-handle-type.
exceed 3 feet.
Dryer
–
Risk of Fire