Using #70 Relay Menu Mode - First Alert FA1220CV User Manual

USING #70 RELAY MENU MODE

Your system may be set up so that certain lights or other devices can be turned on or off by
General
Information using the #70 command from either a keypad or a telephone keypad (if phone module is used).
Ask your installer if this has been done in your system.
To activate relays from a keypad, enter 4-digit security code + [#] + [7] [0]. Follow the keypad
NOTE: Using #70 Menu
Mode requires an alpha prompts described below.
keypad.
To activate relays using the telephone (if phone module is used), first dial the 2-digit phone
access code. When the system acknowledges the access, enter the 4-digit security code + [#] +
[7] [0]. The following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT
NN DEVICE IS OFF
HIT 0=OFF , 1=ON
NN DEVICE IS OFF
HIT THE "*" KEY
Voice: "ENTER DEVICE CODE NOW"
01
Enter the 2-digit number of the device to be activated.
Note that if an invalid number is entered, the system will simply ask
you to reenter the number.
Voice: " voice descriptor DEVICE nn ON/OFF. FOR voice descriptor ON
ENTER 1, FOR voice descriptor OFF ENTER 0"
Press 0 or 1 to turn the device off or on respectively.
"nn" represents the 2-digit device number and voice descriptor is the
relay voice descriptor programmed by the installer.
Voice: " voice descriptor DEVICE nn ON/OFF. TO EXIT ENTER 00 NOW"
From a keypad, press [ ] to continue. The ENTER DEVICE NO.
prompt will appear.
From a telephone keypad, enter 00 to exit, or enter the next relay
number to be programmed. The current on/off state of that relay will
be annunciated as described above. Alternatively, if 6 seconds
elapses with no key depression, the voice module will annunciate the
"ENTER DEVICE CODE NOW" message.
– 34 –