Assembling And Hanging The Fan - Hunter TYPE T Installation And Operation Manual

3-1. To assemble fan to hang down from a flat or angled ceiling, place
the top housing, canopy, and canopy trim ring around the adapter
so that they rest on the fan assembly.
3-2. Feed the wires from the fan through the downrod.
Note: Make sure all the wires are on the same side of the metal
dowel pin inside the dowrod.
3-3. Using the provided Allen wrench, loosen the set screw on the
adapter to install the pipe and ball assembly. Note: When the
pipe and ball assembly is fully installed, 2-3 threads on the pipe
will still be visible; this is normal. Use the Allen wrench to securely
retighten the set screw. Then, secure the top housing by installing
and tightening the assembly screw.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
3-4. Raise the fan and place the ball into the hanger bracket.
3-5. Align the bump on the ball with the notch in the hanger bracket.
(Rotate the fan until you hear the bump pop into place.)
Go to 4 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Allen wrench
3 • Assembling and Hanging the Fan
6
45015-01 • 02/13/08 • Hunter Fan Company
Steps 3-1 – 3-3
Adapter
Assembly Screw
Step 3-2
Steps 3-4 – 3-5
Downrod
Canopy
(with Washer)
Canopy
Trim
Ring
Top
Housing
Set Screw
Hanger Adapter
Notch