Operating And Mounting; The Control; Fan - Hunter TYPE T Installation And Operation Manual

Included with your Hunter fan is a wall control designed for use with
this product. Do not use any wall control other than the one provided.
7-1. Disconnect power to ceiling fan at the main electric panel.
Remove fuse or switch circuit breaker to OFF position.
7-2. Install in a metal or plastic wallbox. Remove wallplate to expose
the wiring, and disconnect the existing switch.
7-3. If two wires are visible, connect each to a Hunter speed control
lead. Use the wire connectors supplied to make the connections.
If a ground wire is provided in your electrical box, attach it to the
ground screw near the bottom of the mounting plate.
Note: If more than two wires are visible after removing wallplate,
consult a qualified electrician for assistance with wiring the
control.
7-4. Gently push wires and speed control into switch box. Attach the
Hunter speed control to switch box with the two screws supplied.
7-5. Remove the knob from the control shaft. Mount wallplate over
control with existing screws.
7-6. Replace knob onto control shaft. Turn knob to the OFF position.
7-7. Restore power at main electrical panel.
7-8. Operate ceiling fan by turning dial to the desired speed.
7 • Operating and Mounting the Control
Blac k
Ho t
120V AC
60H z
Neutral
Wiring Diagram
45015-01 • 02/13/08 • Hunter Fan Company
Blac k

Fan

10