Download Print this page

HP 2100 ER User Manual: Assemble The L-brackets To The Fibre Bridge; Figure 2-1 Assembling L-brackets To The Fibre Bridge

Hewlett-packard fibre channel scsi bridge user guide.
Hide thumbs

Advertisement

NOTE
Figure 2-1
Setting Up the Fibre Bridge
Mounting the Fibre Bridge in a Rack

Assemble the L-brackets to the Fibre Bridge

1. Facing the back of the Fibre Bridge, position the first L-bracket with
the mounting tab toward the back of the rack and pointing away from
the unit, as shown in Figure 2-1.
2. Insert 6x32 screws through the first and third holes from the
mounting tab and tighten. Use the first and third holes (from the
mounting tab end of the bracket) for mounting in a Hewlett-Packard
rack. (Non-HP racks may require mounting holes number two and
four. See note below.)
3. Follow the same procedure for the second L-bracket.
For non-HP racks, allow for cable turn: A minimum distance of 5 inches
(125 mm) is required between the back of the Fibre Bridge and the
backplane of the rack. When installing in racks where the mounting
holes in step 2 produces a distance less than 5 inches (125 mm), use the
second and fourth holes when attaching the mounting bracket to the
Fibre Bridge.
Assembling L-brackets to the Fibre Bridge
H
2-4
Chapter 2

Advertisement

Troubleshooting

   Related Manuals for HP 2100 ER

Comments to this Manuals

Symbols: 0
Latest comments: