Table of Contents
Advertisement
Resetting
To reset the switcher to its factory default settings:
1.
Press and hold the Input 1 button while power is being applied to the unit.
2.
Continue holding the Input 1 button until the power-up sequence completes.
NOTE:
Resetting restores the EDID mode to automatic, with a resolution of
1024x768 @ 60 Hz. If a display is connected at the time of the reset, its EDID
information is detected and stored at the inputs.
SW DVI Plus Series • Operation
17
17
Advertisement
Table of Contents
Need help?
Do you have a question about the SW2 DVI A Plus and is the answer not in the manual?
Questions and answers