Table of Contents
Advertisement
7.
Click
. If the connection is successful,
Connect
the Connected Device section, followed by a green check mark (see
next page).
8.
Click the
Browse
button in the New Firmware File (Optional) section.
9.
On the Open window, navigate to the new firmware file, which has an
and double-click it.
Figure 29.
Open Window for Firmware File Selection
CAUTION: Valid firmware files must have the file extension S19. A file with any
other extension is not a firmware upgrade for these products and could
cause the unit to stop functioning.
NOTES:
•
The original factory-installed firmware is permanently available on the
SW DVI Plus. If the attempted firmware upload fails for any reason, the
switcher reverts to the factory version.
•
When downloaded from the Extron website, by default the firmware is
placed in a folder at:
•
C:\Program Files\Extron\Firmware\SW DVI
•
C:\Program Files (x86)\Extron\Firmware\SW DVI Plus
(Windows 7).
SW DVI Plus Series
SW DVI Plus Series • Remote Configuration and Control
appears in green in
figure 30
on the
extension,
S19
(Windows XP) or
28
28
28
Advertisement
Table of Contents
Need help?
Do you have a question about the SW2 DVI A Plus and is the answer not in the manual?
Questions and answers