2.3.3 Connecting External SCSI Devices
This section provides step-by-step instructions for connecting external
SCSI devices. Refer to
for examples of external cables.
Step 1. Plug the 68-pin connector on one end of a shielded external
SCSI cable into the host adapter's external SCSI connector.
This connector is exposed on the back panel of your computer.
Step 2. Plug the 68-pin connector on the other end of the shielded
external SCSI cable into the SCSI connector on the first
external SCSI device.
Figure 2.11
If you have the correct cable, it matches the external connector.
Figure 2.11 Connecting One External SCSI Device
Terminator
Connecting SCSI Devices
Version 2.3
Copyright © 2002–2004, 2006 by LSI Logic Corporation. All rights reserved.
Section 2.2.2, "External SCSI Cable," on page 2-5
shows how to connect a single external SCSI device.
2-9