Gateway Rear Panel; Install The Voice Gateway - NETGEAR CG3100 User Manual

Gateway Rear Panel

Voice ports
Figure 2. Gateway rear panel
The rear panel includes the following connections, viewed from left to right:
Two voice/phone ports. WIth VoIP service, connect one or two handsets to these ports.
•
Four Gigabit-Ethernet LAN ports. Use these ports to connect local computers.
•
USB port: The USB port is a USB host and can be used for connecting a USB printer.
•
Note: USB functionality is only available with future firmware upgrades.
Power. Power adapter input.
•
• Power On/Off button.
You can return the gateway to its factory settings. On the bottom of
Note:
the gateway, press and hold the Restore Factory Settings button
for over 7 seconds. The gateway resets, and returns to its factory
settings. See

Install the Voice Gateway

Installation is the four-step process summarized here and described in the headings that
follow. Make sure you complete the installation in this order.
Check the Installation Requirements.
1.
Cable the Gateway.
2.
Log in to the Gateway.
3.
Connect to the Internet.and VoIP.
4.
After installation, set up the wireless connection as explained in
Configuration.
NETGEAR Wireless Cable Gateway
Ethernet LAN ports
Factory Default Settings
Connect to the Internet
7
USB Coaxial Power
port cable adapter
connector input
in Appendix A.
Chapter 2, Wireless
Power On/Off
button