Table of Contents
Advertisement
HomePlug Mediaxtream Utility
HomePlug Mediaxtream Utility is a software application that allows you to change the
current firmware of your device. Installation is straightforward and the user interface is
easy to use.
Note: To use HomePlug Mediaxtream Utility, you need a computer using a Windows operating system with
Note:
Note:
Note:
the .NET Framework installed. If you do not have .NET installed, the HomePlug Mediaxtream installer will
install it for you.
Requirements
Your computer must meet the following requirements:
Windows XP (32 and 64 bit), or Vista (32 and 64 bit)
300 MHz Processor
128 Mb of RAM
.NET Framework
Network Interface Card
CD-ROM
128 Mb of free hard disk space
Installation
To install HomePlug Mediaxtream Utility:
1. Insert the Resource CD that comes with HomePlug Mediaxtream package into the
CD-ROM drive.
2. Click the Start button, and then click Run.
3. In the Run dialog box, type D:\Setup.exe (where D: is your CD-ROM drive), and
then click OK.
4. Follow the instructions on the installation wizard.
User Manual
Page 27 of 34
Advertisement
Table of Contents
