Aztech HomePlug Mediaxtream Ethernet Adapter User Manual page 10

User Manual
Step 3
Press Simple Connect Button for two seconds
on HomePlug Y. After you release the button,
the Power LED will start to blink. If the
Power LED did not blink, press Simple
Connect Button again for two seconds.
Make sure to press Simple Connect Button on
HomePlug Y within two minutes after you
press Simple Connect Button on HomePlug X.
The PL-ACT LEDs on both devices will turn ON
once the devices are paired.
Note: Do not press Simple Connect for more than 2 Note: Note: Note:
seconds
Page 10 of 34
Blinking Blinking Blinking Blinking Blinking Blinking Blinking Blinking