Honda FRC800 Owner's Manual page 40

SERVICING YOUR TILLER
4. Clean both filter elements if they are to be reused.
Foam element:
thoroughly, or clean with a high flash point solvent and allow to dry.
Dip the element in clean engine oil and squeeze out all the excess oil.
Excess oil will restrict air flow through the foam element and may
cause the exhaust to smoke when the engine starts.
Paper element:
blow compressed air not exceeding 30 psi (207 kPa, 2.1 kgf/cm )
through the filter from the clean side that faces the engine. Never try
to brush off dirt; brushing will force dirt into the fibers.
5. Install the foam element onto the paper element.
6. Wipe dirt from the
inside of the air cleaner
cover using a moist rag.
Remove the five 5
16.5 mm pan screws,
and remove the pre-air
cleaner guide and case.
Clean the air cleaner
cover and case.
Assemble the pre-air
cleaner case and guide
by aligning the tab of
the case with the
groove of the case
cover.
7. Reinstall the filter
elements and grommet,
and tighten the wing
nut. Install the air
cleaner cover, and
tighten the wing nut.
38
Clean in warm soapy water, rinse and allow to dry
Tap the filter element several times to remove dirt or
5 16.5 mm
PAN SCREW(5)
PRE-AIR
CLEANER
GUIDE
PRE-AIR CLEANER CASE
AIR CLEANER COVER
PRE-AIR CLEANER
CASE COVER
GROOVE
TAB
2
WING NUT
WING NUT
GROMMET
PAPER
ELEMENT
FOAM
ELEMENT