Using Your Steam Mop; The Shark - Shark SE200 series Owner's Manual

Using Your Steam Mop

I MPORTANT: Your steam mop needs
water to make steam! Never use your
steam mop without water in the tank.
S weep or vacuum your floors prior to
cleaning with your Steam Mop.
V isit www.sharkclean.com for other
great quick cleaning products to
complement your Steam Mop, such as
the Shark ® Navigator (model NV350).
4 TOLL FREE: 1-800-798-7398
fig. 1
fig. 2
When you use your steam mop
for the first time or if you have
not used the unit in awhile, it may
take a minute or two for the water
to travel through the pump and
into the heater to create steam.
If you have waited a few minutes
and you still do not see any steam,
reference the troubleshooting
section on page 11.
fig. 3
1 P ull and twist the quick release cord
holder to unwrap the power cord
completely. (fig. 1) Plug into a 120-volt
electrical outlet. (fig. 2) The LED light
will blink blue to show that you are in
standby mode. If the light does not
turn on, reference the troubleshooting
section on page 9. (fig. 3)
2 P ress the STEAM button to activate
the steam. The LED light will turn
solid blue. When the STEAM button
is pressed, the electronic pump will
automatically generate steam and
moisten the micro-fiber pad. (fig. 4)