Getting Started; Assembling Your Steam Pocket® Mop; Steam Mop Assembly - Shark GENIUS S6003C Owner's Manual

GETTING STARTED

When assembling your Steam Mop there may be a little water in or around the water tank.
This is because we test all our Steam Mops before you buy them, so you get a quality
Shark® Genius™ Steam Pocket® Mop.
j
m
n
a Steam Mop Handle
b Quick-Release Cord Holder
c Cord Clip
d Filling Flask
e Steam Mop Pad Release Button
f Steam Mop Body
g Water Tank Lid
s h a r kc l e a n . c o m
a
b
c
d
e
f
g
h
i
k
l
h Steam Control Button
i
Water Tank
j
Mop Head Release Button
k Secondary Release Buttons
l
Steam Blaster® Nozzle
m Genius™ Mop Head
n Dirt Grip™ Pad
ASSEMBLING YOUR STEAM POCKET® MOP
fig. 1
fig. 4
WARNING: ALWAYS make sure the Steam
Mop is UNPLUGGED when not in use. NEVER
fill the Steam Mop or attach the mop head
when the Steam Mop is plugged into an
electrical outlet. Unplug the unit and allow
it to cool before filling it, or attaching or
removing the mop head. To prolong the life
of your Steam Mop, we recommend using
distilled water. Make sure you add only water
to the tank. Chemicals or cleaning solutions
(including vinegar) may damage the Steam
Mop and could be unsafe for you and your
family.

STEAM MOP ASSEMBLY

1 Insert the Steam Mop handle into the
Steam Mop body. Push the handle in until it
clicks into place (fig. 1).
2 Slide the Genius™ Mop Head into the Steam
Mop body. Push until you it clicks securely
into place. (fig. 1) To detach the Genius Mop
Head, press the release button (fig. 2a) and
slide off.
fig. 2a
fig. 2b fig. 3
fig. 5 fig. 6
3 To attach the Dirt Grip pad, spread the
pad on the floor with the pocket side up.
Center the Genius Mop Head above the
pad, then press the pad release button on
the back of the Steam Mop body (fig. 2a).
Both sides of the mop head will drop open
(fig. 2b). Slip the mop head's four corner
tabs into the four corner pockets of the
pad (fig. 3 and fig. 4). Gently press one
side of the mop head to the floor until that
side clicks into place (fig. 5). Repeat on
the other side (fig. 6).
4 Pull down on the water tank lid to open
(fig. 7).
5 Use the filling flask to pour water into the
water tank (fig. 8). Water can be poured
into the tank directly. DO NOT overfill past
the water line on the fill flask. Press the
water tank lid firmly to close it.
fig. 7
s h a r kc l e a n . c o m
fig. 8