Planning; Tools And Equipment Required For Installation - Extron electronics Cable Cubby 200 User Manual

Planning

Determine the best location for the enclosure. Before making any cuts:
•
•
•
•
NOTE: The table to host the Cable Cubby 200 must have a thickness of at least 3/8
Decide on the method for cutting the hole in the table.
•
•
•
Before starting the installation, check with local and state regulations.
•
•

Tools and Equipment Required for Installation

Extron recommends the following equipment (not provided) to ensure the Cable Cubby is
properly installed:
1/4" Hex Nut Driver
Phillips Screw Driver
Ensure that the location where the Cable Cubby is to be installed is convenient for as
many users as possible.
Ensure that the edge on which the lid opens is oriented correctly.
Ensure that there is ample space under the table for cables.
Ensure that the correct template or dimensions are used.
inch (9.5 mm) to ensure that there is enough table material for the mounting
screws to securely fasten the Cable Cubby to the table.
Hand router and template (recommended)
CNC wood router
Jigsaw and paper template
Ensure that the planned installation complies with building and electrical codes.
Ensure that the planned installation complies with the Americans with Disabilities Act or
other accessibility requirements.
Drill
Square
Tape Measure
Marking Pen
Safety Glasses
Cable Cubby 200 • Before Getting Started
Vacuum Cleaner
4