Comfort Adjustments - Pride Mobility Jazzy Select Owner's Manual

V . C O M F O R T A D J U S T M E N T S

COMFORT ADJUSTMENTS

After becoming familiar with your power chair's operation, you may find the need to make some adjustments to
increase your comfort, such as seat height, armrest angle, foot platform height and angle, and controller position.
Refer to the following information before making comfort adjustments.
NOTE: If your power chair is equipped with an optional seating system, please refer to the information pro-
vided in separate manuals.
WARNING! The center of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your authorized Pride Provider has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not
change your seating configuration without first contacting Pride Mobility Products or your
authorized Pride Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
Seat Height Adjustment (Select and Select 6
Only)
You can change the seat height to one of three positions
in 1-in. (2.5-cm) increments.
To change the seat height:
1. Turn off the power to the controller.
2. Ensure the power chair is in drive mode. See figure 11.
3. Disconnect the controller connector from the
power base. See figure 17.
4. Disengage the seat release lever. See figure 17.
5. While holding the lever, swivel the seat left or right
and then pull it up and off of the power base.
6. Loosen the hardware at the rear of the seat post. See
figure 17.
7. Remove the seat height adjustment bolt, washers,
and nut from the seat post. See figure 17.
8. Raise or lower the seat post to the desired position.
9. Reinstall the seat height adjustment hardware to the
seat post.
10. Tighten the hardware at the rear of the seat post.
11. Reinstall the seat.
12. Reconnect the controller to the power base.
NOTE: To rotate the seat, use the seat release lever
located under the seat.
26
SEAT
RELEASE
LEVER
SEAT HEIGHT
ADJUSTMENT
BOLT
CONTROLLER
CONNECTOR
Figure 17. Seat Height Adjustment
www.pridemobility.com
SEAT
SEAT POST
Jazzy Select Series