Table Of Capacities - Axminster AWSMS102 User Manual

Always use (250mm) saw blades with a rated speed in excess of 4,500 r.p.m. The machine is supplied
with a 250mm GP (40 tooth) Saw blade, with a 30mm bore for cutting TIMBER. For precision trimming
e.g. fine cut finish of bead, frame, dado etc., an 80 tooth saw blade is recommended and for cutting
non-ferrous metals, an 80 tooth negative rake saw blade. It is also recommended that you use a
lubricant when cutting aluminium.
DO NOT CUT FERROUS METAL
Because of the geometry of the raising of the lower guard, the incidence of the saw at the intersection
of the fence and the table, the height of the saw washers above the table and the obstruction of the
saw motor body during a right mitre cut, please study the available capacities that are shown below,
and the accompanying notations. The table is drafted with the first measurement being the dimension
against the fence. Although the saw is capable, with the correct saw blades fitted, of cutting plastic,
aluminium, P.V.C., etc, the cutting table deals exclusively with timber.
Timber Size
85mm x 130mm
45mm x 130mm
85mm x 95mm
45mm x 85mm
85mm x 85mm
45mm x 120mm
Please note that the supplied clamp will only clamp timber up to 100mm wide. We do not recommend
that any sawing operations are carried out without stuff being securely clamped to the machine.
Mitre Angle Tilt Angle
0˚
0˚
L45˚
L45˚
R45˚
R45˚
Sliding Arm
0˚ 85mm x 290mm
45˚ 45mm x 290mm
0˚ 85mm x 210mm
45˚ 45mm x 210mm
0˚ 85mm x 210mm
45˚ 45mm x 210mm

Table of Capacities

05