Figure 2-11. Removing The Cpu And Motherboard - HP omnibook OmniBook XE2 Service Manual

Using the Phillips screwdriver, remove the three screws (two long screws on top and one short
screw on the front left).
Technology Code (DD):
Using a Phillips screwdriver, remove the four screws (two long screws on top, one short screw on
the top right, and one short screw on the front left).
Tilt the front of the LED PCA up to detach the two connectors on the bottom.
Lift the PCA out.
LED PCA
CPU module
Floppy disk drive
Motherboard
Note: Omnibook XE2-DB shown. Some details differ from Omnibook XE2-DD.
8. Remove the modem PCA (on the right):
Using the Phillips screwdriver, remove the two screws.
2-18 Removal and Replacement

Figure 2-11. Removing the CPU and Motherboard

Heatsink
Modem PCA
CD-ROM drive
Bottom case
HP OmniBook XE2