Figure 2-3. Releasing The Ram Module Latches - HP omnibook OmniBook XE2 Service Manual

3. Release the two latches at the sides of the RAM module by pushing them gently outward, away
from the sides of the module. The free edge of the module pops up.
4. Pull the module out of the connector. Handle it only by the edges.
Reassembly Notes
Insert the RAM board into the connector at about a 30° angle until it is fully inserted. Then press
down at both sides until both latches snap closed.
HP OmniBook XE2

Figure 2-3. Releasing the RAM Module Latches

Removal and Replacement 2-5