Table of Contents
Advertisement
2.4 FRONT OF THE METER (Continued)
METER BUTTONS
SETPTS Button
In the run mode, press this button to sequentially recall the previous setpoint settings.
After using the
/T1/T2
the SETPTS button to store these new values.
Unless you press the SETPTS,
store your input, the meter will scroll to setpoint 2 the return to the run mode.
If the dual relay option is not installed or if the "L.3=1" on the "LK.CF" menu, pressing
the SETPTS button will display the meter's firmware version.
/T1/T2
Button
In the run mode, pressing the
During the configuration mode or Setpoint modes, use the
change the values of the flashing digit shown on the display and/or toggle between
menu choices, such as "R.1=F" or "R.1=C". When configuring your setpoint values,
press the
/T1/T2
/DEV Button
In the run mode press the
Setpoint 1.
In the configuration or setpoint modes, press the
digit.
and
/DEV buttons to alter these settings as desired, press
/T1/T2
/T1/T2
button to increment the flashing digit from 0 to 9 by 1's.
/DEV button to display the deviation of reading from
or
/DEV button within 20 seconds to
button will scroll to show T1, T2, and T1-T2.
/T1/T2
/DEV button to scroll to the next
6
button to
Advertisement
Table of Contents
