Error Code - Toshiba E-STUDIO230 Operator's Manual

12. ERROR CODE

If an error occurs while using the optional Fax, optional Internet Fax, or optional scan, the error code is
displayed in the status of each log. Take an appropriate action with reference to the following.
Fax/Internet Fax

Error Code

Fax
0011
0012
0013
0020
0030
0033
0042
0050
0053
00B0-00B5
00C0-00C4
00D0-00D2
9
00E8
00F0
00F1
Internet Fax
1C10
1C11
1C12
210
9.JOB STATUS
Cause & Message
Paper jam
Original jam
Door open
Power interruption
Reset
Polling Error
Memory full
Line busy
Security Mismatch in Relay or Mail Box
transmission
Signal Error or Line Condition Error
HDD error
Software failure
Hardware noise
System access abnormality
Insufficient memory
Message reception error
Corrective Action
Clear the jammed printing paper.
Clear the jammed original.
Firmly close the open door.
Check the power interruption report.
(Transmission is cancelled.)
Check polling options setup (Security Code,
etc.), and check if the polling document exists.
Make sure that there is sufficient memory
before making the call again.
Retry communications.
Confirm the remote party's Security Code,
system password, and your setup.
Retry communications. Frequent failures may
indicate a phone line problem. If possible,
move the unit to another line and try your
communications again.
Retry communications. If the error still occurs,
contact your service representative.
Retry communications. If the error still occurs,
contact your service representative.
Retry communications. If the error still occurs,
contact your service representative.
Turn the power OFF and then back ON.
Perform the job in error again. If the error still
occurs, contact your service representative.
When there are running jobs, perform the job
in error again after the completion of the
running jobs. If the error still occurs, turn the
power OFF and then back ON, and perform
the job again.
Turn the power OFF and then back ON.
Perform the job in error again.