Toshiba E-STUDIO230 Operator's Manual page 42

4.SETTING COPY PAPER (Cont.)
4
While pushing the size selection lever in
1
the direction of the arrow, set the side
guide to the desired paper size (indicated
on the bottom inner surface of the
drawer).
- Adjust the side guides with both hands.
5
Push the arrow part (left side) to lock the
size selection lever.
6
Place paper in the drawer(s).
- Place paper face up.
- Maximum number of sheets that can be set. "Acceptable Copy
Paper Types and Sizes"
- Fan the paper well before placing it in the drawer.
- Do not add paper above the line indicated on the guide.
- Do not use creased, folded, wrinkled or damp sheets of paper.
Make sure that a gap of approx. 0.5 mm (less than 1 mm in total) is
left between the paper and the side guide. If there is no gap, this
could cause paper misfeeding.
7
Push the drawer straight into the copier
until it comes to a stop.
- Be sure to push the drawer fully in.
Be careful not to let your fingers be caught when closing the drawer.
This could injure you.
40
1.BEFORE USING EQUIPMENT
Page 36
0.5mm
( 0.02'' )