Instrument Cluster Descriptions - Dodge Challenger 2013 Owner's Manual

220 UNDERSTANDING YOUR INSTRUMENT PANEL

INSTRUMENT CLUSTER DESCRIPTIONS

1. Fuel Gauge
The pointer shows the level of fuel in the fuel tank when
the ignition switch is placed in the ON/RUN position.
2. Trip Odometer Button
Press this button to change the display from odometer to
either of two trip odometer settings. The letter "A" or "B"
will appear when in the trip odometer mode. Push in and
hold the button for two seconds to reset the trip odometer
to 0 miles (km). The odometer must be in TRIP mode to
reset it.
3. Speedometer
Indicates vehicle speed.
4. Electronic Speed Control Indicator Light
This light will turn on when the electronic
speed control is on.
5. Tachometer
The red segments indicate the maximum permissible engine
revolutions per minute (RPM x 1000) for each gear range.
Ease up on the accelerator before reaching the red area.
6. Charging System Warning Light
This light shows the status of the electrical charging
system. The light should turn on when the ignition
switch is placed in the ON/RUN position and remain on
briefly as a bulb check. If the light stays on or turns on while
driving, turn off some of the vehicle's non-essential electrical
devices (i.e., radio) or slightly increase engine speed (if at
idle). If the light remains on, it means that the charging
system is experiencing a problem. See your local authorized
dealer to obtain service immediately.