Dodge Challenger 2013 Owner's Manual page 203

4. Continue to hold buttons until the EVIC display changes
from "CHANNEL # TRAINING" to "CHANNEL #
TRAINED", then release both buttons.
NOTE:
• It may take up to 30 seconds or longer in some cased
for the channel to train.
• If the EVIC displays "DID NOT TRAIN" repeat from
Step 2.
5. Press and hold the programmed HomeLink button.
The EVIC will display "CHANNEL # TRANSMIT". If
the device is plugged in and activates, programming is
complete.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 201
Reprogramming A Single HomeLink Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the EVIC displays "CHANNEL # TRAINING" Do not
release the button.
3. Without releasing
"Canadian/Gate Operator Programming" Step 2 and
follow all remaining steps.
the button proceed
3
with