Barco Galaxy WARP R9040320 Owner's Manual page 56

6. Random Access
Interlaced [On] or [Off]
Read AMDS
How to install the correct settings for the options in the Edit file menu.
EDIT FILE OPTIONS
Source number
Clamp position
Clamp delay
Clamp width
Field polarity
Field select
Vertical refresh
Vertical sync polarity
Select with ↑ or ↓
<ENTER> to toggle
↑ or ↓ to change value
<EXIT> to return
Menu 6-15
Source number
Clamp position
Clamp delay
Clamp width
Sync
pulse
Clamp
pulse
Image 6-2
Example for Clamp position [trailing]
Field polarity
Field select
52
this selection is automatically filled when active file has to be edited. If the image is
wrong due to mismeasurement, use the ENTER key to toggle between [On] and
[Off]. (for interlaced images, 1 frame contains 2 fields).
AMDS = automatic mode detection & synchronization
During the installation of a file with LOAD, the system automatically measured the
horizontal period, the total vertical lines and the interlaced mode. When selecting
Read AMDS, the system remeasures the above indicated items.
1
[leading]
0
10
[pos]
[both]
[sync]
[leading]
The source number of a non-active source can be changed to any other source number. This makes
it possible to create a file for future source numbers.
Clamping determines the black level of the signal. The clamp pulse can be related to the leading or
the trailing edge of the sync pulse. Use the ENTER key to toggle between [leading] and [trailing].
The time between the leading edge of the clamp pulse and the locked edge of the sync pulse. Can be
any value between 0 and 255. Change the value by pushing the cursor key ↑ or ↓.
The width of the clamp pulse can be any value between 0 and 255. Change the value by pushing
the cursor key ↑ or ↓.
Clamp Clamp
delay width
The field polarity function is used for interlaced images. Both rasters of the image could be shifted in a
wrong way (double lines are visible in the image). This can be corrected by forcing the field polarity to
[neg] or [pos]. Use the ENTER key to toggle between [pos] and [neg].
Default [both]
The field select is only used for interlaced images. One frame of an interlaced image contains two
fields, an even and an odd field. The choice exists to project [both] fields on the screen or only the
[even] or [odd] field.
Use the ENTER key to toggle between [both], [even] and [odd].
If the active Stereo Compatibility Option is installed, the field select parameter will be changed
into a [left] and [right] selecting parameter which will be selectable for stereo files. This setting
will then be saved in the active image file.
R5976570 BARCO GALAXY WARP™ 25/03/2004