Barco Galaxy WARP R9040320 Owner's Manual page 28

4. Connections
Two Way
hardwired
remote
CTRL 3
Null Modem Connector
Slave 1
Two Way
hardwired
remote
CTRL 3
Slave 2
Two Way
hardwired
remote
CTRL 3
Image 4-4
RS232 Setup
How to connect a COM800 Setup
Always use the Barco COM 800 Splitter, R9827941 (240V) or R9827948 (110V), when using the COM 800 protocol.
1. Use a data cable with at least 9 cores and 2 DB9 female connectors, just cross the pin 2 and pin 3 connection to make a Custom
Null Modem Cable. (image 4-5)
2. Use the Custom Null Modem Cable to connect the COM 800 port of the master-projector to the 'To Switcher' port on the frontside
of the COM 800 Splitter. (image 4-6)
3. Continue by connecting the slave projectors to the 'To Proj.' connectors on the backside of the COM 800 Splitter (image 4-6).
4. When dealing with more than 4 slave projectors, the 'To Proj.' connectors on the backside of the COM 800 Splitter can also be
used to connect extra COM 800 Splitters (image 4-6).
24
Master
Diagnostic Code
Hardwired
Green operational
remote
Red Stand-by
CTRL 2
Hardwired
Sync OK IR
remote
CTRL 1
RS 232/422 IN RS 232/422 OUT
Diagnostic Code
Hardwired
Green operational
remote
Red Stand-by
CTRL 2
Hardwired
Sync OK IR
remote
CTRL 1
RS 232/422 IN RS 232/422 OUT
Diagnostic Code
Hardwired
Green operational
remote
Red Stand-by
CTRL 2
Hardwired
Sync OK IR
remote
CTRL 1
RS 232/422 IN RS 232/422 OUT
Daisy Chain to next Slave ...
IR-Reciever
COMM PORT 10(/100)BASE-T
Read instructionsbefore
connecting periphals
IR-Reciever
COMM PORT 10(/100)BASE-T
Read instructionsbefore
connecting periphals
IR-Reciever
COMM PORT 10(/100)BASE-T
Read instructionsbefore
connecting periphals
R5976570 BARCO GALAXY WARP™ 25/03/2004