Trouble Shooting - Emerson PREMIUM SELECT CF4801AB00 Owner's Manual

!
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER
BEFORE TROUBLE SHOOTING YOUR FAN.
TROUBLE
1. Fuse or circuit breaker blown.
1. Fan will not
start.
2. Loose power line connections to the fan, 2. Check line wire connections to fan and switch
or loose switch wire connections in the
switch housing.
1. Blades not attached to fan.
2. Fan sounds
noisy.
2. Loose screws in motor housing.
3. Screws securing fan flanges to
motor hub are loose.
4. Wire connectors inside light kit housing
rattling.
5. Screws holding blades to flanges are
loose.
1. Setscrew in motor coupling is loose.
3. Fan wobbles
excessively.
2. Setscrew in hanger ball/downrod
assembly is loose.
3. Screws securing fan blade flanges to
motor hub are loose.
4. Fan blade flanges not seated properly.
5. Hanger bracket and/or ceiling outlet
box is not securely fastened.
6. Fan blades out of balance.

14. Trouble Shooting

PROBABLE CAUSE
16
SUGGESTED REMEDY
1. Check main and branch circuit fuses or circuit
breakers.
wire connections in the switch housing.
WARNING: Make sure main power is
!
turned OFF.
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor housing
are snug (not over-tight).
3. Check to make sure the screws which attach
the fan flanges to the motor hub are tight.
4. Check to make sure wire connectors in light kit
housing are not rattling against each other or
against the interior wall of the switch housing.
WARNING: Make sure main power is
!
turned OFF.
5. Tighten screws securely.
1. Raise motor cover and tighten setscrew securely.
2. Tighten the setscrew in the hanger ball/
downrod assembly.
3. Check to be sure screws which attach the fan
blade flanges to the motor hub are tight.
3. Check to be sure the fan blade flanges are
seated firmly and uniformly to the surface
of the motor hub. If flanges are seated
incorrectly, loosen the flange screws and
retighten according to Steps 12 and 13
in the Assembly Instructions.
5. Tighten the hanger bracket screws to the outlet
box, and/or secure outlet box.
6. Interchanging an adjacent (side-by-side) blade
pair can redistribute the weight and result in
smoother operation. Or use supplied balancing
blades.
U.L. Model No.: CF4801 and CF4501