Emerson PREMIUM SELECT CF4801AB00 Owner's Manual page 6

3. Ceiling Fan Assembly
6. Install the setscrew (supplied in loose parts bag) in
the motor coupling and tighten using the 5/32"
setscrew wrench (supplied) (Figure 3).
7. Screw two 1" threaded studs (provided) into the
motor (Figure 4). Leave approximately 7/8" of the
stud extending above the motor. Slide the motor
cover over the downrod and rotate the cover until the
threaded studs protrude; install two knurled knobs
(supplied) to secure the cover.
NOTE: Make sure the red and brown leads are
capped with wire connectors. Make sure the red,
brown, and yellow wires and wire connectors are
completely inside motor coupling cover and not
pinched between the motor coupling cover and
motor.
8. Position the ceiling cover over the downrod. Be sure
the cover is oriented correctly, with the large opening
at the top (Figure 5).
9. Reinstall the hanger ball on the downrod as
follows. Route the motor leads through the hanger
ball and slide the hanger ball over the downrod
(Figure 5). Install the pin through the holes at the top
of the downrod and slide the hanger ball up the
downrod, aligning the ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball.
A loose setscrew could create fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure
to verify that the pin and setscrew are properly
installed could result in the fan falling.
10. The blue, black and white leads exiting the downrod
are 80-inches long. Before installing fan, measure up
approximately 6 to 9-inches above the ball/downrod
assembly. Cut off excess leads and strip back
insulation 1/2-inch from end of leads.
(Continued)
Figure 3
WIRE
CONNECTORS
RED LEAD
BROWN LEAD
MOTOR
Figure 4
HANGER BALL
DOWNROD
CEILING COVER
Figure 5
6
DOWNROD
SETSCREW
KNURLED KNOB
MOTOR
COUPLING
COVER
WIRE CONNECTOR
YELLOW LEADS
1" THREADED
STUD
7/8"
PIN
SETSCREW
U.L. Model No.: CF4801 and CF4501