Care And Cleaning - Sunbeam Flip & Grill HG3200 Instruction/Recipe Booklet

Care and Cleaning

To clean after use
Always turn the power off and remove the
plug from the power outlet and the control
probe from the probe inlet before cleaning.
Allow the Flip & Grill
cleaning.
Do not cut food on top of the cooking plates.
Do not leave plastic utensils in contact with
the cooking plate while in use.
®
Teflon Platinum Pro
Your grill features a special scratch and
abrasive-resistant non-stick coating that
makes it safe to use metal utensils when
cooking.
However Sunbeam recommends that care is
taken with the non-stick coating particularly
when using metal utensils.
Do not use sharp objects or cut food on the
grill. Sunbeam will not be liable for damage
to the non-stick coating where metal utensils
have been misused.
The element in the grill plate is cast in, so it
is safe to fully immerse in water.
Wash the grill plate in warm soapy water
using a mild household detergent and a soft
washing sponge.
Do not use abrasives or metal scourers as
they may scratch the non-stick surface.
A bottle brush may be used to clean the drip
holes in the grill plate.
Be sure to clean the handles after each use.
The grill plate is also dishwasher safe.
Dry the grill plate and probe inlet thoroughly
before storing.
to cool before
™
Non-Stick Coating
™
Moulded base
The base can be wiped over with a damp
cloth or washed in warm soapy water using a
mild household detergent and a soft washing
sponge.
Do not use abrasives or metal scourers as
they may scratch the exterior surface.
Do not place the moulded base in the
dishwasher.
Drip tray
Lift the metal drip tray out from the base
and pour any excess grease or liquid into a
container and dispose appropriately. Do not
pour oil or fats down the sink.
Wash the metal drip tray in warm soapy water
using a mild household detergent and a soft
washing sponge.
Dry the drip tray thoroughly before storing.
Do not place the metal drip tray in the
dishwasher.
Control probe
If cleaning is necessary, wipe over with a
damp cloth.
Important: Do not immerse the control probe
in water or any other liquid. Do not place the
control probe in the dishwasher.
Do not knock or drop the probe as this can
damage the probe. If damage is suspected,
return the control probe to your nearest
Sunbeam Service Centre for inspection.
Note: Before inserting the control probe
into the probe inlet, ensure the interior of
the inlet is completely dry. To do this wipe
interior of probe inlet with a dry cloth or
shake out excess water vigorously.
Storage
Allow the grill to cool completely and clean
it after each use and dry thoroughly before
storing it away.
7