Black Box AC1120A User Manual page 26

Model AC1120A, AC1121A, AC1122A, AC1123A
9.
To set a port number (IP port that controls the Matrix):
SPN1000 <cr> stands for Set Port Number.
Command:
Response:
OK .................................................. if command completed successfully.
Error........................................................................... if command failed.
10.
To get a device/host name:
GDN <cr> stands for Get Device Name.
Command:
BB1123-A
Response:
This is the host name assigned to the IP port; it is independent of the
name assigned to the matrix (NU command), though you can use the
same name if you wish!
11.
To set a device name:
SDNnew_name <cr> stands for Set Device Name.
Command:
Response:
OK .................................................. if command completed successfully.
Error........................................................................... if command failed.
12.
To reboot the system for the changes to take effect:
If you change the IP address, Subnet mask, etc., the changes do not take effect
unless you reboot the unit. You can do this by unplugging the AC from the unit
and reconnecting it in a few seconds, or by using the FB command discussed
earlier. However you must first exit the IP setup mode by hitting Esc,
24
Note on Device Name