Emerson JULIANNE CF220GBZ00 Owner's Manual page 9

BP7360 JULIANNE 9/19/07
SCROLL
COLLAR
SETSCREW
GROMMET
COUPLING
COVER
MOTOR
HOUSING
Figure 9
15. Unscrew the three scroll retaining
screws from the scroll collar. Using
the hex wrench (supplied), unscrew
the setscrew in the scroll collar until it
clears the inside of the collar. Slide
the collar over the downrod (Figure
9), and position the collar 7 or 8-
inches above the coupling cover, then
tighten the setscrew.
16. Align one downrod scroll with one of
the slots in the scroll collar and secure
the scroll in place using a scroll
retaining screw (previously removed)
(Figure 9). Repeat this procedure for
the remaining two downrod scrolls.
NOTE: The downrod scrolls must
properly mate with the slots in the
scroll collar to
alignment. Securely tighten the screws.
17. Loosen the setscrew and slide the
scroll collar down the downrod until
the decorative scrolls rest upon the
top of the motor housing (Figure 9).
Tighten the setscrew.
11:15 AM Page 9
It is critical that the pin in the hanger ball
SCROLL
is properly installed and the setscrew
RETAINING
securely tightened. Failure to verify that
SCREW
the pin and setscrew are properly
DOWNROD installed could result in the fan falling.
SCROLL
DOWNROD
18. Place the ceiling cover over the
downrod. Then reinstall the hanger
ball (Figure 10) on the downrod as
follows. Route the three 80" motor
leads through the hanger ball and
slide the hanger ball over the
downrod. Position the pin through the
two holes in the downrod and align
the hanger ball so the pin is captured
in the groove in the top of the hanger
ball. Pull the hanger ball up tight
against the pin and securely tighten
the setscrew in the hanger ball. A
loose setscrew could create fan
wobble.
DOWNROD
Figure 10
19. The fan comes with blue, black and
white leads that are 80" long. Before
installing
approximately 6 to 9-inches above top
assure proper
of hanger ball/downrod assembly. Cut
off excess leads and strip back
insulation 1/2" from end of leads.
20. You have now completed the initial
assembly of your new ceiling fan. You
can now proceed with hanging and
wiring your fan.
9
! WARNING
PIN HANGER BALL
SETSCREW
CEILING
COVER
the fan, measure
U.L. Model No.: CF220
up