Emerson JULIANNE CF220GBZ00 Owner's Manual page 8

BP7360 JULIANNE 9/19/07
11. Remove the hanger ball by loosening
the setscrew in the hanger ball until
the ball falls freely down the downrod
(Figure 7). Remove the pin from the
downrod, then remove the hanger
ball. Retain the pin and hanger ball for
reinstallation in step 18.
PIN
HANGER
BALL
DOWNROD
Figure 7
NOTE: If you have an eight-foot ceiling,
you will have to use the 6" downrod
(supplied) in order to maintain the
necessary blade-to-floor clearance of
seven feet.
12. Unscrew the two upper setscrews
(Figure 8) until they clear the inside of
the motor coupling. Then separate,
untwist and unkink the three 80"
motor leads. Route the motor lead
wires through the downrod. Align the
clevis pin holes in the downrod with
the holes in the motor coupling. Install
the clevis pin and secure with the
hairpin clip (Figure 8). The clevis pin
must go through the holes in the
motor coupling and the holes in the
downrod. Be sure to push the straight
leg of the hairpin clip through the hole
near the end of the clevis pin until the
curved portion of the hairpin clip
snaps around the clevis pin. The
hairpin clip must be properly installed
to prevent the clevis pin from working
loose. Pull up on the downrod to
make sure the clevis pin is properly
installed.
11:15 AM Page 8
It is critical that the clevis pin in the motor
coupling is properly installed and the
setscrew securely tightened. Failure to
verify that the pin and setscrew are
properly installed (as shown in Figure 8)
could result in the fan falling.
HAIRPIN
CLIP
SETSCREW
MOTOR
COUPLING
Figure 8
13. Tighten the two upper setscrews
(Figure 8) securely while pulling up on
the downrod.
NOTE: The setscrews must be properly
installed as described above, or fan
wobble could result.
14. Make sure the grommet is properly
installed in the coupling cover, then
slide the coupling cover over the
downrod until it rests on the motor
housing (Figure 9).
NOTE: If you installed the 6" downrod,
the three downrod scrolls and scroll
retaining ring will not be installed.
Disregard
proceed to step 18.
8
WARNING
!
DOWNROD
CLEVIS
PIN
SETSCREW (2)
steps 15 through 17;
U.L. Model No.: CF220