AIMB-253 Mainboard
Fan Power Connectors: CPUFAN1, SYSFAN1
The fan power connectors support system cooling fan with +12V. When connecting the
wire to the connectors, always take note that the red wire is the positive and should be
connected to the +12V, the black wire is Ground and should be connected to GND. If
the mainboard has a System Hardware Monitor chipset on-board, you must use a spe-
cially designed fan with speed sensor to take advantage of the CPU fan control.
Important
Please refer to the recommended CPU fans at Intel
consult the vendors for proper CPU cooling fan.
Front Panel Connector: JFP1
The mainboard provides one front panel connector for electrical connection to the front
panel switches and LEDs. The JFP1 is compliant with Intel
tivity Design Guide.
PIN
1
2
3
4
5
6
7
8
9
2-12
SENSOR
+12V
GND
CPUFAN1
JFP1
10
Power
-
Switch
+
Power
LED
2
1
JFP1 Pin Definition
SIGNAL
DESCRIPTION
HD_LED +
Hard disk LED pull-up
FP PWR/SLP
MSG LED pull-up
HD_LED -
Hard disk active LED
FP PWR/SLP
MSG LED pull-up
RST_SW -
Reset Switch low reference pull-down to GND
PWR_SW +
Power Switch high reference pull-up
RST_SW +
Reset Switch high reference pull-up
PWR_SW -
Power Switch low reference pull-down to GND
RSVD_DNU
Reserved. Do not use.
SENSOR
+12V
GND
SYSFAN1
®
®
/ AMD
®
Front Panel I/O Connec-
9
Reset
+
Switch
-
-
HDD
LED
+
official website or