Connectors; Chassis Intrusion Switch Connector: Jci1; 44-Pin Ide Connector: Eide1 - Advantech AIMB-253 User Manual

Connectors

Chassis Intrusion Switch Connector: JCI1

This connector connects to a 2-pin chassis switch. If the chassis is opened, the switch
will be short. The system will record this status and show a warning message on the
screen. To clear the warning, you must enter the BIOS utility and clear the record.
44-Pin EIDE Connector: IDE1
This 44-pin EIDE connector connects to an optional converter that enables connection
to one 44-pin EIDE device and one 40-pin EIDE device, such as hard disk drives, CD-
ROM and other EIDE devices.
IDE1
Important
If you install two hard disks on cable, you must configure the second drive to
Slave mode by setting its jumper. Refer to the hard disk documentation sup-
plied by hard disk vendors for jumper setting instructions.
1
CHASSIS
2
GND
JCI1
Connect to 44-pin
EIDE device
Connect to EIDE1
Hardware Setup
Connect to 40-pin
EIDE device
2-9